Leisuwash specializing in manufacture Automatic Car Wash Machine, Touchless Car Wash , Automatic Touchless Car Wash, touchless car wash equipment, robot car wash, smart car wash system, leisuwash 360, leisuwash leibao 360, laserwash 360, leisuwash touchless car wash machine, leisu wash touchless car wash automatic, leisu wash 360 high pressure touchless car wash equipment, robo car wash, touch free car wash, leisuwash 360 touch free car wash, leisuwash 360 price, automatic car wash price, leisuwash in malaysia, no touch automatic car wash machine.
Leisuwash 360 touchless car wash machine high intelligent high quality, with car wash + car care + drying process totally, each car wash takes time 1 minute to 5 minutes which depends on the car wash mode.
Leisuwash 360 car wash automatic touchless is distinguished by the use of new, more advanced American technology of Automatic Car Wash. The 3D technology of washing is based on the use of a special bent-shaped manipulator with 360 rotations. Rotating around the car, the manipulator reads data about its contours and adjusts itself to the optimum distance for washing.
Automatic Car Wash Machine,Leisuwash 360 Glow,Car Wash Machine,Vehicle Washing Machine Hangzhou Leisu Cleaning Equipment Co.,Ltd , https://www.sdtouchlesscarwash.com
Possible causes of vibration disk not working
1. The power supply voltage is insufficient 2. The connection between the vibration disk and the controller is broken 3. The controller fuse is blown 4. The coil is blown 5. The gap between the coil and the frame is too small or too large 6. There are parts stuck between the coil and the frame 7, the vibration plate against a hard object, a top plate or chassis encounter other devices <br> <br> vibration plate vibration fatigue or too slow, or irregular feed sporadically, may be due to:
1. Spring break 2. The floor is too thin 3. The mounting table is defective and lacks hardness. If it is suspended on the equipment table, the vibration will be too weak, the thickness of the table should be at least 1-1/2 ", so that it will not absorb vibration. The cylindrical support must be equipped with triangular support.
4. The table is not horizontal 5. There are debris 6 in the dish. The air gap of the coil should be as small as possible 7. Excessive machine rhythm causes the part to slip from the vibration plate.
8. Power grid fluctuations 9. The controller needs to be readjusted to adapt to grid fluctuations.
10. Parts problems: poor, curved, oily, etc. 11. The fastening screws of the disc and the base are not tight or in the wrong position.
12. Too many parts 13. Improper chassis adjustment 14. In the event of a material change, the disk should be reconditioned and the chassis 15 readjusted. In the case of using air blowing, there may be some problems, may exist: air pressure instability, air pollution, water or oil, these contaminants will stay on the surface of the vibration plate, leading to slow or even not feed the speed. The gas source must be clean and dry, equipped with an independent pressure regulator and filter. Do not use rigid tubes to reduce feed performance. Flexible hoses should be used.